M18 Battery Holder for Milwaukee Packout – Drop-In Lid Insert

Keep your M18 batteries on top of your Packout, right where you need them. Press this insert into one of the slots on top of a Packout lid and slide a battery on. No screws, no tools.

The insert fits the slot so tightly it stays put while you carry or roll your stack. You have to really pull to get it back out. The battery slides onto the rails and locks with its own latch.

Features

• Fits all Milwaukee M18 batteries, including CP, XC, High Output and Forge packs
• Drops into the slots on top of Packout lids, with no screws or tools
• Very tight fit keeps it in place while you move your stack
• Locks with the battery's built-in latch for secure grab-and-go
• Strong PETG: tough and heat-resistant
• Available in black or red

Note: fits the slots on top of Milwaukee Packout lids. It does not fit Packout wall panels or wall plates.

How to install

1. Find an open slot on top of your Packout lid.
2. Press the insert firmly into the slot.
3. Slide your M18 battery onto the mount until it clicks.

Also for the wall and M12

Hang more batteries on the wall with the M18 Battery Wall Mount or the Horizontal M18 Mount. Running M12 too? See the Packout M12 Battery Mount.

Designed and 3D printed in the USA.

Layer FabWorks is not affiliated with or endorsed by Milwaukee Tool. Milwaukee, M18 and Packout are trademarks of Milwaukee Electric Tool Corp.; the names are used only to describe compatibility.